Reply
New Member
Posts: 8
Registered: ‎06-18-2018

Hysteresis / dead area in analog sticks

Hello,

I push the stick all the way to full throttle and the display in TS2017 shows me full throttle. Now I pull back the stick slowly to the center but nothing seems to happen in TS2017 for the first centimeter. After approximately one centimeter the stick in the simulation starts moving. Same happens when I pull back the joystick to activate the dynamic brake. I pull the stick slowly back to the center but the brake persists for one centimeter. Only after that the brake slowly starts to get switched off.
Can I do anything about it? If feels very unnatural because the absolute position of the Cab Controller's stick seems to be independent from the the stick in the simulation. Instead of using my feel I need to watch the screen. As if the stick is very lose or something.

Any help will be apprecited.

I didn't find the right solution from the Internet.

References:
http://xkeys.com/forum/viewtopic.php?id=103
Teaser video production studio

Thank you.