04-20-2016 08:30 AM
I have posted a new set of FMC-IMAGEON IP Cores and Tutorials for Vivado 2015.4, which can be accessed on the zedboard.org community website:
There are also versions for previous versions of the Xilinx tools:
04-26-2016 06:23 AM - edited 04-26-2016 07:12 AM
I followed the Getting Started guide for 2015.2, I'm getting the following error: "VITA sensor failed to initialize".
This is my setup: a MicroZed board with the Embedded Vision Card and the Avnet Python camera module. In the TCL script, I commented out everything except the last 3 lines (to compile for the Microzed-7020 + FMC Carrier Card).
Any idea of what could be the problem?
04-26-2016 07:07 AM
The following are different hardware platforms :
- MicroZed Embedded Vision Kit => supports the PYTHON-1300-C camera module
- FMC-IMAGEON => FMC module supporting the VITA-2000-C camera module
You cannot mix and match the ref designs for different hardware ...
If you have a MicroZed Embedded Vision Kit, then you need to use ref designs for this kit.
In your case, you should be using the following:
05-01-2016 03:25 AM
06-10-2017 07:26 PM
03-22-2018 11:39 AM
I'm trying to follow these tutorial for a college project, but I can only find 2013.3 IP Tutorials files. Not just the getting started files.
The computers have Vivado 2014.4 installed. Where can I get the IP tutorials files for that version?