09-16-2015 11:25 PM
I want to program a DSP processor in OMAP-L138 SOM-M1 module by external JTAG. I have a Blackhawk XDS560v2-USB System Trace Emulator.
When I’m trying to program DSP I get an information from Code Compose Studio that DSP is held in reset - see attachment.
Is on the Avnet Spartan-6/OMAP Co-Processing Development Kit board any jumper or switch, that i have to setup to connect with DSP? DSP is held in reset.
I can’t find this Information in Started Guide.
09-17-2015 01:27 AM
Finally I've got it.
1. Setup the Boot Mode for DSP-only Development -> Boot Mode = EMU DEBUG. DIP Switch on S7:
8 = ON
7 = OFF
6 = OFF
5 = ON
4 = 3 = 2 = 1 = OFF.
2. Before start programming click switch SW 8 - Software RESET, and then you can load the program and debug it.