03-02-2011 04:32 PM
When connecting to the target with CCSv4 via XDS100v2, it is possible to get the "Error connecting to the target" error.
See the attached image for a picture of the error dialog box.
Solved! Go to Solution.
03-02-2011 04:33 PM
The first thing to try is to press the SW8 (OMAP_RST) on the hardware. Then click Retry in the error dialog box.
If the problem persists, double-check the following:
1) Make sure that the OMAP-L138’s boot mode is set for “EMU Debug”
2) Make sure that there is a valid USB connection between the PC and connector J18
- The green LED (D19) should be on
04-27-2011 10:33 AM
Any other possible fixes for this problem?
I have re-installed the XDS100v2 drivers and still cannot connect to the target emulator.
D19 is lit and the correct S7 switches are set. I am running CCS in a virtual machine -- any chance this is screwing up the drivers?
04-27-2011 01:00 PM
I have personally run CCSv4 in a Windows7x64 virtual machine on a Mac running OSX 10.6.x using VMWare Fusion with no problems.
What is your configuration? Host OS? Virtual Machine software (VirtualBox, VMware)?
I don't suppose you have a native Windows box you could use to test the CCSv4 connection to the XDS100v2?