Posts: 1
Registered: ‎11-05-2013

Problem Running Getting_Started Design for Virtex 6 DSP Dev Kit

Hello All


I just purchased Virtex-6 DSP Dev Kit.  Right now trying to run the Getting_Started program to verify that the board is functional.

However I'm having problem at chipscope step, after i 'open cable/ search JTAG chain) and "configure" the console state "INFO: Found 0 Core Units in the JTAG device chain"..

Hence I cannot proceed to the next step "Trigger Setup" and monitor the output.


FYI I'm using ISE 13.4 and windows 7 professional.


Any advice & suggestion is highly appreciated.